Here's a Kaleidoscope simulator in BASIC. I made some small alterations to the original:
Press any key but SPACE, 0 and V to 'turn' the Kaleidoscope.
Press 0 to auto-turn.
Press V to clear and start again (stop the auto-turn simulation for clear to work).
Press SPACE to break out.
Regards,
Shaun.
Kaleidoscope simulator
Kaleidoscope simulator
- Attachments
-
- SCOPE.P
- (485 Bytes) Downloaded 281 times
Re: Kaleidoscope simulator
Hi,
I made a version using PRINT AT rather than PLOT; this will work on 2K machines or better.
Edit - I decided to make it 1K to save you the trouble
Regards,
Shaun.
I made a version using PRINT AT rather than PLOT; this will work on 2K machines or better.
Edit - I decided to make it 1K to save you the trouble
Regards,
Shaun.
- Attachments
-
- SCOPE2-1K.P
- (477 Bytes) Downloaded 242 times
-
- SCOPE2.p
- (1.63 KiB) Downloaded 263 times
Re: Kaleidoscope simulator
I preferred a square mosaic created by the previous version. Issue 2 works fine but the mosaic is bit overstretched horizontally for my taste.
Anyway, good job!
Anyway, good job!
Claudius
----------
----------
Re: Kaleidoscope simulator
Hi,
Thanks for the feedback. I could make each version appear to be circular rather than square. Let me think about that one. Should be easy enough.
Regards,
Shaun.
Thanks for the feedback. I could make each version appear to be circular rather than square. Let me think about that one. Should be easy enough.
Regards,
Shaun.