I have both a ZXPand (and AY daughter board plugged in) as well as a ZXPand+ where my SD card carrier with micro SD card works in the ZXPand+ but when I swap the SD card carrier with micro SD card over to the ZXPand it does not work (no K). I was thinking perhaps the ZXPand needs it's own SD card carrier with micro SD card with a lower version of firmware perhaps. Could this be the reason why my ZXPand is not working. It's been a while since I have had them turned on also. (TS1000).
Thanks - Tim
ZXPand vs ZXPand+ ?
Re: ZXPand vs ZXPand+ ?
I found this firmware link for the ZXPand: https://www.sinclairzxworld.com/viewtop ... f=13&t=913
and this for the firmware link for the ZXPand+: viewtopic.php?f=13&t=2430&p=25720&hilit=ZXPANDFW#p25720
and this for the firmware link for the ZXPand+: viewtopic.php?f=13&t=2430&p=25720&hilit=ZXPANDFW#p25720
Re: ZXPand vs ZXPand+ ?
put the sd in after powering on and see if it is recognised do a CAT
what's that Smell.... smells like fresh flux and solder fumes...