Opinion poll - AY channel mixing.

[1024MAK]

Also MIDI is all USB these days so no need to include DIN sockets in your module when its done.

Uhh, I wanted to see a Zeddy module with a row of ten nice DIN sockets all in a row

Mark

[Moggy]

After inflating the autopilot, surely all you need to force mono crash landing mode is a switch shorting the left and right channels?

Mark

Have you been at the sherry again?

[Moggy]

Also MIDI is all USB these days so no need to include DIN sockets in your module when its done.

Uhh, I wanted to see a Zeddy module with a row of ten nice DIN sockets all in a row

Mark

I have an old ISA MIDI unit with 5 sockets if that's any good.

[1024MAK]

Poll added, as it appears voting is back in fashion

Mark

[Moggy]

Vote cast!

VOTE MOGGY!!!!!

(I have a big dog and know where you all live)

Yes I have been at the single malt again.

[sirmorris]

I've tried the new 2k mixer, sounds ok. A little different but just as good. As it simplified the build it's going in Softer stereo FTW!

[Moggy]

I've tried the new 2k mixer, sounds ok. A little different but just as good. As it simplified the build it's going in Softer stereo FTW!

Bless you good sir knight.

At this point Moggy calls off his killer dog Brenda and cancels his train ticket to Oxford

[siggi]

This is the AY-board ("Mr. X") made by Sascha: channel C is fed into channel A and B. AFAIK the 470 Ohm resistors are now 1K:

http://forum.tlienhard.com/phpBB3/viewt ... 208#p29133

Siggi

[sirmorris]

Thanks Siggi!

[Moggy]

Still a bit low at 1k, more current less voltage, I find the 2.2k set-up drives my mixing desk or speakers better than 1.6k or less plus the stereo image is less harsh .

Each to their own just my personal view.