ZX81 / TS1000 handheld keyboard replacement

[tdg8934]

I finally finished my handheld ZX81 / TS1000 keyboard replacement. Thanks to Mahjongg and his site: https://revspace.nl/ZX81%2B34_ZX81_clone

Here are some pictures.

image1.JPG (171.42 KiB) Viewed 2865 times

image2.JPG (162.21 KiB) Viewed 2865 times

image3.JPG (84.36 KiB) Viewed 2865 times

[tdg8934]

More pics.

image4.JPG (129.75 KiB) Viewed 2864 times

image5.JPG (72.2 KiB) Viewed 2864 times

image6.JPG (100.5 KiB) Viewed 2864 times

[tdg8934]

Final pics:

image7.JPG (106.79 KiB) Viewed 2864 times

image8.JPG (101.74 KiB) Viewed 2864 times

image9.JPG (127.38 KiB) Viewed 2864 times

[mahjongg]

Looks good, (yeah, I'm here these days).
Perhaps the holes could have been a tad smaller, that would have looked a bit better, but well done.
You could have pre-drilled the holes with a very small drill and used the perforated board as a guide, so the hole locations became a bit more precise, or perhaps use a pencil and the perforated board, to mark the hole locations on a paper, as drill guides would have worked too.
Anyway, it worked out I see.

I trust it is working well?

[tdg8934]

Thanks for the feedback. Yes all works well (in either the TS1000 keyboard or my handheld keyboard)

Tim