zx spectrum in zx81 case

Posts: 28
Joined: Tue Dec 19, 2017 9:02 pm
Location: St Albans, UK

Re: zx spectrum in zx81 case

Post by McKlaud » Mon Jan 08, 2018 11:56 pm

rune wrote:
Sat Jan 06, 2018 3:27 pm
Nope still the same log. The CPLD is warm. I've checked continuity from the 10 pin header to CPLD and all is good. Voltage to the board is good.
To be honest I bought five (5) CPLD chips from a Far East supplier and only 2 are fine. Anyway, good luck with your board.

@superfo designed an interface to the Issue 1. The interface is a combination of the Kempston type joystick port and the IF2 cartridge slot. It works with any ZX Spectrum and is compact and very handy. See below.



And the last but not least, below is a teaser about the Issue 2 board. This PCB is still hot and arrived to me a few days ago.


User avatar
Posts: 319
Joined: Sun Apr 17, 2016 1:44 am
Location: Texas

Re: zx spectrum in zx81 case

Post by gammaray » Tue Jan 09, 2018 5:32 pm

nollkolltroll wrote:
Tue Nov 21, 2017 6:30 am
Interesting choice of travel...
Since there is a CPLD or FPGA sitting there, it would presumably be possible to create a ZX80/81/Spectrum switchable in the same case?
Interesting and worthy concept, I wish I knew how!

There would have to be a change in bus layout. Maybe a driver/buffer board to switch signals?

There would have to be a keyboard overlay. Larger ROM for both monitors (Op Sys)

And other things without being an emulator... May be too complicated to implement electrical layout.
Finish what you start. Truth is over the mountaintop or six feet under.
4 x TS1000, 2 x TS1500 , 2 x timex 2040 printer, 1/2 x timex 2020 cassette deck, ZXPAND+AY, ZeddyNET, ZXBlast..., unfinished Spectrum...Still no life!

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest